Product Description

DALTEX Pore Filler is designed as a pore filler for internal resin bound / stone carpet systems. The DALTEX Pore Filler exhibits superior pseudoplastic properties making it ideal for squeegee application.

Application

Surface Preparation

DALTEX Pore Filler should be lightly squeegeed onto the surface. Start at one end/edge of the area and work towards the exit keeping the wet edge.

Aggregate Size

For best results we recommend application onto DALTEX resin bound aggregates up to 3-4mm in size. As the filler dries it may shrink back slightly. In a larger void this may leave a pinhole.

Coverage Rate

Typical application rate for 1-3mm aggregates is 1.2m²/kg. A second coat can be applied, coverage will depend on the remaining voids between 3-4m²/kg.

Spills

It is important not to spill the material. Ensure that any spills are squeegeed over immediately. Any spills allowed to dry too long will be seen through the overcoat.

⚠️ High Humidity Areas

In areas of high humidity or where the surface is likely to come into contact with water regularly, once the filler is fully dry and transparent, we recommend rolling on one or two coats of DALTEX Rejuvenator.

Technical Specification

Type

Thixotropic water-based acrylic

Form Supplied

White Gel

Non-Volatile Content

48-51%

pH Value

8-9

Storage

Store out of direct sunlight in a humidity-controlled atmosphere at 8-25°C. It is critical that the product is always protected against frost. Wherever possible store in original unopened containers until needed. Shelf life is 6 months from the date of manufacture.