Immediate Aftercare

Curing Time

Do not walk on your new Resin Bound surface for 24-48 hours, and do not drive on resin for 48-72 hours after installation. These times are temperature dependent and we would recommend you always follow the installer's advice for exact timings.

No Leaks/Drips

Ensure there are no leaks/drips on the curing resin because excess moisture will significantly weaken and discolour Resin Bound surfaces during the curing period. Continuous drips/leaks cause erosion in the long term, and will degrade the surface.

⚠️ Footprints Cannot Be Removed

Ensure pesky people or animals cannot walk on the Resin Bound surface. Footprints cannot be removed! Devices can be used to deter animals, and we would recommend to place tape/barriers around the perimeter.

5 Most Important Points to Remember

Static Wheel/Small Turning Circles

Pressure exerted from static turning can dislodge surface aggregates. Once the matrix has broken, the surface will weaken and break away. It is very important that vehicle wheels are not turned when static or slow moving, and small turning circles should be eliminated in the driveway design.

Impact Damage/High Point Loads

Take care not to drop heavy equipment on to the driveway, such as the placement of skips. Also be aware - skips can often leach rust on to your driveway which you may not be able to clean. Car jacks can depress the surface of Resin Bound and should be placed on a wooden board for load distribution.

Chemicals and Staining

Petrol, solvents etc should not come into contact with resin surfacing ideally. In the event of spillages, dilute and clean immediately. Solvents and some chemicals will degrade the resin binder, resulting in stone loosening over a period of time.

Leaching/Discolouration

Like all paving surfaces, Resin Bound will discolour if covered long term permanently with a close contact object. Discolouration occurs from leaching and lack of exposure to air/sunlight. An example would be a flat bottom plant pot or a storage box. Use raised plant pots, and do not store items like storage boxes on the surface.

Rejuvenating Your Surface

A great way to extend the life of your driveway is by sealing the surface after a deep clean. This can be done using a diluted polyurethane UV resin sealer – contact your installer for more information. A good time to carry out this enhancement would be 2-4 years after installation of the resin surface.

Cleaning Advice

General Cleaning

Power wash with lance at 90-degree angle, at least 300mm from surface. Start at a higher distance and work closer if needed.

Weeds & Moss

Can be easily jet washed away. Treat organic growth with appropriate products. Regular cleaning prevents buildup.

Oil & Detritus

Remove spillages promptly with absorbent material. Use emulsifying degreaser for stains. Act quickly for best results.

Rust & Tyre Marks

Use Non-Acidic Rust Stain Remover. Steam clean or scrub tyre marks with detergent and a stiff brush.